Wine & Glass Set Holder

These Wine holder sets are made of sublimation MDF board 1/4 inch thick.  You can customize the white on top which is for sublimation.  The back side is made of a wooden color back as default.

Check out the digital download area for sublimation Heat press transfer images or template.

The middle hole insert into the wine bottle , and holes on edge is for hanging the glass cup. This design is for 2 cups hanger.

Sublimation Instructions: 

Heat press settings:

• - temperature - 400 degrees F 60 sec

• 5 x 9 inch for size

Steps:

1. Remove the protective plastic coating if any from the substrate.

2. Use a lint-free towel to remove any loose debris from the substrate if necessary.

3. Position the substrate onto the transfer and adhere transfer to substrate using heat tape. 4. Place the transfer and substrate in the press onto the paper towel (transfer on top of substrate).

5. Place the teflon sheet or scratch paper over the transfer.

6. Press the items using the sublimation settings listed above.

7. Remove items from the press immediately. Use heat resistant gloves if necessary - the items will be very hot.

8. Remove transfer from substrate.